Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…
view full answer...I have exactly what you need to hook the exterior propane tank up to your trailer. For this, you will want the MB Sturgis Sturgi-Stay T-Fitting w/ Hose for Type 1 Valve part #103614-MBS. The red female type 1 connector on the t-fitting will attach…
view full answer...The signal booster of the TireMinder kit #TPMS-TRAILER normally installs on the trailer near the sensors. The USB charger would be used if there wasn't a solar source to charge the batteries. Without any access to light the battery life of…
view full answer...Yes, you will want the same equipment to connect (2) 40 lb. propane tanks together as long as your 40 pound tanks feature a standard ACME or P.O.L. fitting (which most do). You will want an (1) Automatic Changeover RV LP Gas Regulator #37207-30395.…
view full answer...The measurement that is typically needed most is the drain opening of the sink itself. The most commonly found drain diameter in RV sinks is 2 1/8". When you're shopping for strainers and baskets, they'll be sized according to drain…
view full answer...It looks like you want a 10' hose that connects to a 20 pound tank (with a type-1 connector) on one end, and a heater with a POL female connector (with regulator) on the other end. The first problem I see is the use of two low-pressure…
view full answer...On the side of the MB Sturgis RV Propane hose part #100041-144-MBS it's max pressure rating of 350 psi is listed.
view full answer...If your MaxxFan Plus Roof Vent #MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part #MA00A01150K or the batteries are just in need of a change. I do also recommend verifying that you're…
view full answer...The Furrion tankless water heater part #FR68SR would be a great option for you. It's tankless like you are wanting which is a better design than a tank kit and it also has a door kit that comes with it that measures 18 by 18 inch so it would fit…
view full answer...You would still be able to use a tee like you're wanting to but you'll have to make a few modifications in order to fit the regulator in place again. The POL fitting #204037-MBS on tees like part #103606 can be removed and you can install a…
view full answer...In order to correctly measure a propane hose you will need to measure end to end (fitting to fitting). The propane hoses we sell are by the foot so this may make it easier to determine what you need. It is also a good idea to get a hose that is a bit…
view full answer...Your Greystone WF2613R fireplace has actually been discontinued, and its replacement parts are no longer available, unfortunately. I know it's not what you're wanting to do, however since your fireplace and its parts are no longer available,…
view full answer...Filter Your Search
Contact and Help