Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Yes, based on the picture you submitted the Replacement Fan Motor Assembly Kit #FVK8017-00 that you referenced will be the correct replacement fan and motor setup.
view full answer...Yes, there is a measurement you can take to determine what size brakes you need and if they will fit your existing drums. You will want to measure the diameter of your drums. I have included a diagram detailing the dimensions you will need to find.…
view full answer...In the USA a tandem axle utility trailer with a gross vehicle weight rating (GVWR) of 7500-lbs should have brakes installed. Any trailer over 3000-lbs must have brakes on all wheels in most states, but laws do vary. Some states require braked axles…
view full answer...Absolutely! If you would rather not connect the trailer to your tow vehicle, you can simply use a separate car/truck 12V battery to test the electric brakes on your trailer. You can apply power to the appropriate brake input pin on the trailer…
view full answer...In regards to the Hopkins Engager Push-To-Test Trailer Breakaway Kit part #20400, there are only two wires with the black being power so it should be run to the positive battery terminal and the blue being brake output so it should be run to the…
view full answer...On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…
view full answer...The Dexter "8-248" is a hub assembly for 3,500 lb axles that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in both 5 on 4-1/2" and 5 on 4-3/4" bolt patterns therefore you would need to…
view full answer...I've attached pictures showing the pretty much every dimension of the Replacement Exterior Pop-Up Roof Vent #RV-626-062. If you need any other measurements please reply back and I'll get them for you.
view full answer...The best way to handle the grounds for lights on an aluminum trailer is to mount a junction box like #38656. You can then run ground jumpers from all lights back to the junction box and also connect the 4-pole such as #W787268. The box provide both a…
view full answer...I believe the tack room vent on your Sundowner is smaller than standard size vents and we don't have anything to fit your current vent. I had another customer a while back that measured their Sundowner and it was 13x13 inches so not a standard…
view full answer...Typically, you want between 16" and 24" of wire to extend past the trailer tongue but it really depends on your particular vehicle and the location of the trailer plug on your vehicle. You want enough wire so that there is not tension on…
view full answer...The screw holes of the Replacement Exterior Pop-Up Roof Vent #RV-626-062 that you referenced are 3/16 of an inch in diameter. Typically we recommend number 8 screws for the install of this. A number 11 size rivet is commonly associated with this hole…
view full answer...Related Searches
Filter Your Search
Contact and Help