Install this heavy-duty hitch on your vehicle so that you can securely tow your gooseneck trailer. Store the removable ball upside down in the hitch when you aren't towing to get complete bed access. Square ball base won't turn in hitch.
Install a Companion fifth-wheel hitch in your truck bed with this custom kit. Better than a traditional mounting kit, this setup doubles as a gooseneck hitch when the fifth wheel is removed, and the underbed design allows for full bed access.
We sure can! The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.
Thanks for all of the info on the axle you have on your trailer. Since you have a Dexter 5,200 lb axle with a 6 lug bolt pattern the correct hub/drum you need is the Dexter #K08-201-98.
I found a wire coloring for your 2018 Chevy Colorado on a Chevrolet forum it should be wired as such. Yellow: Left stop/turn signal, Green: Right stop/turn signal, Brown: Tail lamps/parking lamps, Black: Ground, Grey: Back-up lamps, Orange: Battery,…
There is one option that has the right dimensions to replace the Atwood 87891, which is a handle from Stromberg Carlson: - Replacement Crank Handle for Stromberg Carlson Landing Gear #LG-119226 The metal shaft where it attaches to the jack has an…
Yes, the Replacement 17-rpm Lift Motor for Fan-Tastic Vent B Series #FVK6010-80 can be used in place of the 7-rpm Lift Motor FVK6050-80, as long as you swap the wires like you mentioned.
Yes, the B&W Companion #BWRVK3400, which uses the Base #BWRVB3405 you referenced, will fit the Custom Underbed Installation Kit #BWGNRK1012-5W for your 2015 GMC Sierra 2500. This is one of my favorite towing setups because you gain the ability to…
The Replacement Drum for M-3 Dual Ramp Springs - Right Hand #DRUM-M-3RH or the Replacement Drum for M-3 Dual Ramp Springs - Left Hand #DRUM-M-3LH is what you are seeking. You also want the Replacement Cables for Conventional Ramp Door Spring -…
Because the 8-14.5 tire that you've got sits on a 14.5" wheel, so you wouldn't be able to switch tire sizes with anything that we have available without also switching to a new wheel as well. If you've got a 6 on 5-1/2" bolt…
The ID for the TImken 1380 is .875 and the 17520/17580 is .625. None of the hubs we offer are compatible with spindles that have a diameter that small. Honestly, you'll likely have a difficult time locating replacement hubs compatible with that…
Mobile home axles are designed for a one time use and do not have a load rating. You may be able to find hubs and drums and other hub components for the specific spindles you have on the axles but that can be very difficult as mobile home axles…
Hello Brandon. Well, this isn't reddit, but we do offer one spindle that used the LM67048 (1.25" inner diameter) inner bearing and the LM11949 (0.75" inner diameter) outer bearing. Take a look at the Agricultural Spindle for 3,000-lb…
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Filter Results
