Result: 75270

Hey Tim, The ZCI Circuit Protected Vehicle Wiring Harness #119250KIT is compatible with LED lights and has been used as a go to for years for people who have LED trailer lights. The light function is supposed send a tiny bit of voltage from the…

We have installed the Gorilla-Lift Utility Trailer Tailgate Lift Assist #GL1 on similar trailers to your Gorilla 10' trailer with a 2' dovetail. I have included an image below of a similarly designed trailer which has a taller gate. The…

The brake controller install harness part #3031-P is the correct install harness for a Tekonsha Primus brake controller part #TK90160 in a 2023 Toyota Tacoma.

The height of the sides of the bed on your 2015 Ford F-350 is a critical measurement you will want to know. since you said the height of the bed when the tail gate is down is 41.5 inches, and the height of your fifth wheel trailer king pin is 54.5…

To gain height and add clearance your best option is to raise your trailer with what is called an over/under conversion kit, which moves your trailer's leaf springs to the top of your axle and lifts your trailer approximately the same amount as…

Basically if you look at the rear of your 2019 Audi Q5 and you don't see a trailer connector then you don't have one from the factory. Worst case scenario you can call your local dealer with your VIN and they will be able to confirm either…

We have a hitch for your 2023 Lexus RX 350h with the Curt part #C29VV but the Draw Tite you mentioned does not work. The Curt would still allow the rear kick sensor to open the rear tailgate but you would have to kick to either side of the hitch.

The Draw-Tite item #DT73QR installs below the bumper. This hitch is perpetually backordered due to Draw-Tite being bought out so I have a way better option for a hitch for your 2023 Lexus RX 350. I recommend the Curt Trailer Hitch item #C29VV. This…

I can tell you John, I had the same concern when I installed a receiver on my Acura RDX. While my receiver did not entirely prevent the use of the kick sensor for the hands free liftgate it did limit the area I was able to kick due to the receiver.…

The Curt Trailer Hitch Receiver #13432 you found is for Jeep Wranglers and will not be able to fit your 2023 Ford Bronco. While we currently have not received any updates that the Curt Trailer Hitch Receiver #C76WR which fit the 2021 and 2022 model…

We sell replacement install hardware for all of the hitches we carry with the part #RHK. On the product page you would just need to select the manufacturer and enter the part number and we'll ship you out the correct install hardware.

When trying to install the Draw-Tite Max-Frame Trailer Hitch Receiver #75270 on your 2011 Honda Odyssey did you spray the WD40 and let it sit for 15 minutes or did you spray it and then scrub it with a wire brush for 15 minutes? If you haven't…