Result: 5000 lbs axle

Hey Roland, thanks for reaching out! Overslung axles are a special order situation and we unfortunately only have standard axles here at etrailer. With that being said, you can order a standard axle that meets your specs and then use the Dexter…

Thank you for reaching out! The best thing for your situation is to go with the 3,500 lb Dexter Axle #T3584F-8974 you are looking at. While you can upgrade your axles to the 5,200 lb #e55GR, you won't really see a benefit from it unless you also…

I believe you're asking if you could mount a size 205/75-15 trailer tire, on a 15 inch wheel that is 6 inches wide. If so, the answer is yes! 205/75-15 trailer tires can use a 5, 5-1/2, 6, 6-1/2 inch wheel, so you're good to go. If you…

U-bolts like the 3 inch axle U-bolt part #SP01-060 are measured from the inside of the U. So it has 3 inches between the U. Axles have a bow to them that has to always point down otherwise the wheels will be way out of alignment. You will need to…

We do have a solution for you although we don't carry a leaf spring for a 5,200 lb axle that has the same dimensions as Leaf Spring #e27SR. What does have the same dimensions is the 26" Double-Eye Spring for 6,000-lb Trailer Axles #e94SR…

We have a folding trailer tongue hinge that could work for the purpose you describe, as long as your trailer frame isn't constructed of aluminum. You could use the Fulton Fold Away Coupler Hinge, part #FHDPW330300. The hinge kit is designed for 3…

To determine if your 2020 Kia Sorento has a towing package you'll need to remove the sidewall panel just behind the rear driver's side wheel well. Inside you'll find a wiring harness connector that will allow you to plug in a tow package…

The 10 inch Electric Brake Assembly, #23-26, requires a 7/16 inch, fine thread bolt for installation. Use part #6-17 for installation. The lock washer is also 7/16 inch. Part #5-8 is the correct washer for this application.

For your flat bed trailer, I recommend using 12 gauge wire like #12-1-1 at the minimum, but preferably 10 gauge wire like #10-1-1. Both of these wires are sold by the foot, so you can order the exact length you are needing. If you were to use a…

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

You should use 10 gauge wire for electric brakes which is pretty much the standard size for electric braking applications because it can handle the amperage better over the long distance from a brake controller to the electric brakes. For a nice…

Actually, there's a little more to it than that. The magnets on the #K23-478-479 are a little different, but the primary difference is the mounting bolt pattern. On a typical 3500 lb brake assembly, the mounting studs will all be 2-7/8 inches…