Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The 15x6 inch wheel #AM20535 will accept 205/75-15 tires, 225/75-15 tires, and 7.00-15LT tires. I have linked the 15 inch tires we carry for you. For a valve stem you can use #AM20904.
view full answer...There are only two different size valve stem holes on trailer wheels, 0.453" for anything smaller than 16" diameter and part #0.625" for anything 16" or larger. Therefore, the Ford Factory TPMS is only compatible with wheels…
view full answer...First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…
view full answer...Hi Chad! There are 2 ways to tell the difference between driver side and passenger side Dexter Axle brake assemblies; the first is by looking at the sticker on the inside, and the second is by looking at the brake assemblies as a whole. For example,…
view full answer...Biggest difference is the Dexter assemblies part #23-468-469 are made in the US and have basically the best reputation for trailer brake assemblies. If you are looking for the nicest setup that would be the most reliable this would be the route I…
view full answer...On a wheel, offset is where the wheel mounting surface is relative to the center line of the wheel. Back spacing is the distance from the mounting surface to the outer edge of the wheel. So if the wheel you have now is 5 inches wide with a 3 inch…
view full answer...For your 2017 Ram 2500, I recommend the B&W Custom Installation Kit, #BWRVK2602. This custom-fit bracket kit lets you mount to existing holes in your vehicle's frame to minimize drilling and measuring. This will reduce installation time and…
view full answer...Hey Steve, Out of the options we offer the Aluminum AM03 Series Gunmetal Gray Machined Trailer Wheel #AM28NR does look the closest to your Colorado's wheels. This is a 15" wheel with a 5 on 4-1/2" bolt pattern so you'll want to…
view full answer...To replace your AL-KO seal part 363497 you can use the double-lip seal set #RG06-070. These have an inner diameter of 2.250-inches (to match your spindle diameter) and an outer diameter of 3.376-inches (to match the bore on your 12 x 2-inch hub/drum…
view full answer...We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…
view full answer...If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is #HBA-10 and it has different wire colors, see picture. So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away switch.…
view full answer...Both the MORryde Rubber Equalizers #MR87ZR and Dexter E-Z Flex Suspension Kit #K71-652-00 are achieving the same result. They are doing so with slightly different designs but end up with the same result. I recommend using the Dexter E-Z Flex…
view full answer...Filter Your Search
Contact and Help