Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The U-Bolts used on the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88338 will allow you to install the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BWGNRK1012 on your 2015 Chevrolet Silverado 2500. The U-bolts are wide enough…
view full answer...There is not an easy way to verify the tongue weight of a fifth wheel trailer if you do not already have the trailer. The best way to find the tongue weight of your fifth wheel trailer is to use a commercial scale like those at truck stops or at…
view full answer...Hi Duane, Air Springs are better for leveling loads and will typically give you a rougher unloaded ride quality so these might not be the best option for your setup depending on what your intended use is. Air springs are the best option when it comes…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…
view full answer...I sure can Bob and thanks for the information! Since you have a Lippert 3,500 lbs axle you'll be able to use the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles item #AKHD-545-35-EZ-K, you were looking at. These have a 5 on 4-1/2 lug nut…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…
view full answer...It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
view full answer...There are a number of differences between the Firestone Ride-Rite Air Helper Springs #F2445 and Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88299, starting with fit. While the Air Lift will fit all models of the 2018 Toyota Tundra, the…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…
view full answer...I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part #AKEBRK-35-SA (3,500 Axles) Dexter…
view full answer...Filter Your Search
Contact and Help