Hey Trent, from what I found your 1995 Jeep Grand Cherokee uses an 18 inch diameter clutch fan like the part #D17118. The part number you referenced is 17 inches so it wouldn't work but I would recommend measuring to verify this.
Hey Bob, Landing gear components aren't all interchangeable between brands so I'd need to know the exact model to find replacement parts for your current system. If you're just wanting to replace the landing gear as a whole then I'll…
Hey John, the Air Lift kit part #AL57230 that fits your 2007 Dodge Ram 1500 is compatible with in-bed hitches but not mega cab models. The part #AL57295 is a fit for the mega cab models and fits with in-bed hitches. The part #AL88295 fits mega cab…
Hello Jeremy, thanks for reaching out. The Air Lift Air Helper Spring Cradles #AL59DQ will only work with the Air Lift brand bellows-style air bags. They will not work with the Firestone air bags.
Nissan refers to their cab style that is most commonly considered to be "extended cab" as a King cab. The Curt hitch part #13831 that you referenced is a fit for the King Cab 2003 Nissan Frontiers so it would work well for you. I also…
Using Loctite when installing a trailer hitch is not required but it can certainly be used to create an even stronger bond. Blue Loctite like the Blue Stick #LT37643 is plenty sufficient for this application. As long as the hardware for your hitch is…
We have a dual fan setup that is VERY close to what you are looking for but is 1 inch deeper than what you mentioned with the part #D16833. This is rated for 3,750 CFM, is 24 inches wide, 17 inches tall, and 4-1/2 inches deep. If the depth is an…
Yes, there is a bolt that goes all the way through that holds the Timbren Rear Suspension Enhancement System item #TGMRG25C in place. I have linked the instructions and an installation video below so you can see the steps involved and all the tools…
Each of the fans of the Flex-a-lite Dual 13-1/2" Electric Radiator Fans w/ Shroud #FLX295 can flow up to 2,300 CFM. Also worth mentioning is that the likelihood of one of the fans failing is very low.
The cupholder portion of the Optronics #2409171B is adjustable between roughty 2-1/2" and 3-3/4" so this would be a good fit for you if you're referring to the beverage holder dimensions. The casing dimensions on this cup holder are…
Unfortunately the Lippert electric jack #LC285318 has had this issue and they haven't found a solution yet but say they are working on it. Currently, the only thing you can do is replace the jack. The issue with both the motor and the nut is the…
Your internet site is very well organized and easy to use...My order was shipped very promptly and included everything I ordered...All in all this was a simple procedure for what can be a complicated order. I would use your company again or recommend you to others. Your selection was broad and your prices fair.
Filter Results
