What Finish Does the Trailer D-Ring Tie Down # LRB1 Have
Published 12/03/2014
Question:
Part #LRB1 d-ring for tiedown. What type of finish does this part have?
asked by: Bill
0
Expert Reply:
The Trailer D-Ring Tie Down # LRB1 that you referenced has a zinc finish to prevent corrosion.
Check out the review video I attached as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: Transition Plates For Trailer Ramp Door That Is 80-1/2" Wide
- Q&A: Replacement Inner Tube Gooseneck Coupler 4" Diameter For BullDog Bx1 25k
- Article: Cargo Tie-Down Methods
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole
- Q&A: Center Cap for Trailer Wheel With 5 Inch Pilot Hole Diameter
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers