How Many Holes Get Drilled to Install the CargoSmart Wheel Chock # 3481731
Updated 08/12/2014 | Published 08/11/2014
Products Featured in This Question
Question:
How many holes are needed to mount on the trailer?
asked by: Pat
Helpful Expert Reply:
According to the installation instructions you will use 4 attachment points when installing the CargoSmart Motorcycle Wheel Chock for E-Track or X-Track Systems - 7" Wide Tires Item # 3481731 to your trailer. So you will need to drill 4 holes. I recommend adding the Snap-Loc E-Track Tie-Down Anchor - Square Mounting Hole - Bolt On - 1,000 lbs - Matte Zinc - Qty 1Item # SLSZ to attach the chock to the floor of your trailer.
Product Page this Question was Asked From
CargoSmart Motorcycle Wheel Chock for E Track or X Track Systems - 7" Wide Tires
- E Track
- E Track Wheel Chocks
- CargoSmart
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Does The Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers 325-GH-513 Come With The Pintle Lock?
- Q&A: Recommended Ramp Door Transition Plate That Can Handle a Pallet Jack
- Q&A: Wheel Chock Recommendation for Harley in Trailer
- Q&A: Grease Seal to Replace Part Number 174253tb
- Q&A: Best Way To Charge A Lithium Battery With A 7-Pin Trailer Plug On A 2021 Ram 2500
- Q&A: Installation Recommendations For E-Track Horizontal Track System In Trailer With 2x6 Floor
- Q&A: Repair Kit for etrailer Ram Jack # TJD-8000S
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: The Best Electric Trailer Jacks of 2025
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller Installation: Starting from Scratch