Can Trailer D-Ring, # RR01-C Handel Two 200 Pound Loads Pulling in Opposite Directions
Updated 07/26/2011 | Published 07/24/2011
Products Featured in This Question
Question:
Can this this tie down take two 200lb loads at 180degrees apart, like I am trying to pull it apart?
asked by: Richard
0
Expert Reply:
Since the load is within the working load limit and minimum breaking strength, it will handle the application that you have described provided that the surface it was mounted to could also handle the load.
Since the load is right at the capacity of D-Ring RR01-C, I recommend going with something rated higher for safety. You can use the Recessed Trailer D-Ring Tie Down with Backing Plate, # RR5K.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-9/16" Wide - Recessed Mount - 400 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 400 lbs
- Bolt-On
- Folding
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Length of Bolts in Demco Hardware Kit 6166
- Q&A: Can Brophy D-Ring Tie Down Anchor Install on Steel Floor
- Q&A: Equalizer Recommendation that is 7-3/4 inches Long and 2.875 inches Tall
- Q&A: Replacement Gear and Handle for Bulldog Jack BD195362
- Q&A: Replacement Lippert Control Box for 140-1227 Box
- Q&A: Choosing D-Ring Cargo Tie Downs for Toy Hauler Trailer
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Fifth Airborne Replacement Trailer King Pin with Air Cushions by Fifth Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Basics of Tie-Down Anchors