Width of the Mounting Bracket for the Brophy D-Ring Tie Down Anchor # LRB1
Updated 02/13/2018 | Published 02/12/2018
Question:
What is the width of the part that has the two holes. I am trying to find something that will fit within a U-post that has a 1 9/32 vertical slot and the holes on the post are 1inch apart. thank you
asked by: Ruth C
0
Expert Reply:
I went out to the warehouse and found that the width of the mounting bracket for the Brophy D-Ring Tie Down Anchor # LRB1 measured 1-3/4".
I have attached a photo with the dimensions listed for you to check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: How Wide are Hellwig Contact Helper Springs HE89FR
- Q&A: Replacement Inner Tube Gooseneck Coupler 4" Diameter For BullDog Bx1 25k
- Article: Cargo Tie-Down Methods
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Center Cap for Trailer Wheel With 5 Inch Pilot Hole Diameter
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers