Brophy D-Ring Dimensions For Tie Downs
Updated 03/13/2017 | Published 03/10/2017
Question:
D-ring Dimensions. working for the federal government Navy at NAVFAC Pearl Harbor Hawaii. Please can I get a quote for 14 each of the D-ring P/N LRB1 with freight charges. My address is as followed: Honolulu, Hawaii 96853
asked by: Terry S
Expert Reply:
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs # LRB1 have a 3-1/2 inch outside to outside length, a 2-1/2 inch inside length, and a 2-3/8 inch inside width. The mounting bracket is 2 inches center to center on the mounting holes. I've attached some videos to help.
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: Transition Plates For Trailer Ramp Door That Is 80-1/2" Wide
- Article: Cargo Tie-Down Methods
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: Center Cap for Trailer Wheel With 5 Inch Pilot Hole Diameter
- Q&A: Chrome Wheel Center Cap for 5-1/8 Inch Diameter Pilot Hole
- Article: Converting Your RV Water Heater to Tankless
- Q&A: What is the Difference Between 235/80-16 and 235/85-16 Trailer Tires
- Q&A: Offset of Wheel/Tire Combo # AM34964 Does it Include Center Cap and Lug Nuts
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?