Safety Chain D-Ring Mount Recommendation for a Small Utility Trailer
Updated 07/09/2015 | Published 07/07/2015
Products Featured in This Question
Question:
Can I use this D-ring to mount the safety chains on the tongue of my small utility trailer? Maximum load will be between 750 to 1000 pounds including the weight of the trailer. Attached is a picture of trailer the tongue is 3/16 wall 2inch box tubing... Thanks
asked by: Bob M
0
Expert Reply:
The D-Ring part # LRB1 that you referenced has more than enough capacity to be used for safety chain mount on your small utility trailer.
A chain like the part # 2118-605-04 would work great as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 2-3/8" Wide - Surface Mount - 4,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 4000 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Continue Researching
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: Difference Between Brophy Swivel D-Ring Anchors # RR6K and # RR06
- Q&A: Comparing O-Track Cargo Control System And L-Track System
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Can PingMaster 5000 Wireless Trailer GPS Tracker Battery Be Replaced
- Q&A: Are Trailer Wheel and Tire Combos Balanced
- Q&A: Economical Option for Trailer Wheel With 5 on 5-1/2 Bolt Pattern and Trailer Tires
- Article: Cargo Tie-Down Methods
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers