2007 GMC Yukon XL Grille

When you say "Bike started to come off the back of the trailer" does that mean that you are using the T2 Pro XTR #TH69TX on the back of a trailer? If so then that could be the problem. The issue is that there is significantly more…

The Thule T2 Pro XTR 2 Bike Hitch Mounted Folding Rack, item #TH83JV, will accept up to 5 inch wide tires but, unless you have over 1 inch of clearance between the fender and the front tire on your cruiser with a fender, you will not be able to…

You are right that the strap you mentioned isn't the correct fit, and I checked with Thule and there isn't a standalone strap available for a T2 Pro XT, but there is still an option for you. What you would need instead is to replace…

When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the floor of the truck bed and 1…

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

The Furrion 2-in-1 Range Oven with Glass Cover #FR97KR is actually really close to the dimensions of your 21 inch Magic Chef so this would be an easy and great replacement solution that would fit perfectly.

The problem isn't that you have a Tundra because you can install a fifth wheel rail kit #RP50084-58 into your 2012 Toyota Tundra without a problem. Any industry standard fifth wheel hitch will fit into the rail kit. The problem you'll…

Yes, you could use Valterra Bladex Waste Valve for RV Black Water Tank - 3" Hub to 3" Spigot Item #T40 with an automatic black water draining system such as Valterra EZ Valve Electric Waste Valve - 3" Hub x Hub x Bayonet -…

I went out to our warehouse to measure the Valterra EZ Valve Double Electric Waste Valves part #E84-8 for you. The wire lead on the actual valve is about 8-1/2" long whereas the wire lead on the switch is about 7' long for each…

We don't have the specific number but what I think will be more helpful for you is the distance from the rear most portion of the bumper to the hitch pin hole. Which for the #41932 that dimension is 1-1/2 inches. Check out the picture I…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The hitches we offer for your vehicle are designed for use with the factory bumper, but we do have options that might work for you. The deepest drop custom hitch we offer for that truck is the B&W #BWHDRH25187 which has a 6-1/2 inch drop.…