Vehicle Style: 6-1/2 Foot Bed Change
Gooseneck Hitch Specs:
Recommended Trailer Wiring:
Installation Notes:
No drilling required to install the frame brackets of installation kit. Installation rails are rated to meet vehicle manufacturer's tow ratings - see vehicle owner's manual
More Information >Videos
for Gooseneck Hitch
Help Articles
for Gooseneck Hitch
Expert Answers
for Gooseneck Hitch
The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use.…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you…
view full answer...The factory prep package on a 2018 Ram 3500 is pretty apparent so odds are you don't have this if you are unsure. If the indentations for the four outer pucks and center gooseneck hitch ball are present but there are no actual…
view full answer...To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you…
view full answer...Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…
view full answer...Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…
view full answer...According to B&W the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit part #BWGNRK1020 is about a 2 hour install by a professional. All the Hardware is provided. I have attached the…
view full answer...Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an…
view full answer...You can replace the Lippert Rhino pin box on your Brinkley 5th wheel. The right one though is going to depend on the pin weight of your trailer. Here are the options that will work to replace the Lippert Rhino: - Pin Weight of 1,500 lbs - 3,500…
view full answer...You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…
view full answer...The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept…
view full answer...The two parts you mentioned (#RP87FR and #RP39FR) that fit your 2021 Ford F-350 Super Duty will both allow the ability to pull a gooseneck trailer with a gooseneck ball or use a 5th wheel hitch in the puck system. The only difference between them…
view full answer...Filter Products (2)