Exposed edges on trailers and cabinets can chip, wear down, or leave a rough finish if they're not covered. This nosing trim covers those raw edges to protect them from damage and create a finished look along panels, doors, or stone guards.
If you're replacing damaged trim or trying to match an existing setup, getting the right dimensions and profile is critical. This nosing trim is not trailer-specific. To get the right fit, you'll need to match it to your existing trim by measurement. If you're replacing a section, measure your current trim and compare:
The shape matters just as much as the dimensions. If the profile doesn't match, the rail may not sit properly or direct water away as intended. Even small differences can prevent the new piece from lining up with your existing trim. If you're not sure, take a few measurements and photos of your current setup and reach out to etrailer support for help comparing options.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone, Steve here with etrailer.com. Let's take a look at our P&F Products Nosing Edge Trim for enclosed trailers. Now, folks, this is gonna be an aluminum construction. It's gonna be a great cover to shield raw edges on your trailer or cabinets, and it has a nice, versatile use. It's a little numb, you can cut it to length. It measures 93 and 1/2 inches long overall by 3/16 of an inch thick.
And it's approximately one and 5/16 inches wide. So I do wanna zoom in a little bit better than this even, and give you a better look at that edge here. So if you look, it has a nice lip right here on it. And again, overall the total thickness is 3/16 of an inch. Now because this is aluminum, again, it's gonna be sturdy, it's gonna resist corrosion.
Again, you can cut it to length. It's gonna be great for covering those unfinished edges, whether it's on your enclosed trailers, cabinets, or even stone guards. And so if you had a right angle like this, this would go good to sit there and hug it flush, and just give you a nice finished look. And because it has that curved edge over it, that nosing as it's called, that's gonna make it to where you're not gonna be nicking yourself on sharp edges and those kind of things as well. So again, a great option for you.
This is the P&F products, nosing edge trim in aluminum. I'm Steven. Thanks for watching.
Ratings & Reviews
Trailer trim makes my trailer look brand new.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.