Most Popular Board/Ski Lock for Jeep Patriot

Great product at a great price. Fit an adult snowboard, two sets of adult skis (one set stacked, one set side by side because of how close the bindings were to the roof), and a set of youth skis. Fit snug. Only got up to about 73mph on the highway, but no issues. Some normal fluttering on the snowboard/skis. If you have a torque meter to tighten the bolts that's ideal but I didn't. I just got them snug enough to where I pulled back and forth on the rack and it didn't move.

Works awesome with the snowboards, easy to attach/detach, and durable. Locks and holds fine, initial ordering was confusing and hard to figure out since it’s not a package, and had to get individual components. Rhino rack could definitely improve that! Otherwise it would be 5 star.

Looks great on the vehicle. Had a little struggle tightening onto the cross bars but adapted and overcame!

It's a ski rack so its not all that exciting. I like that it is small for storage reasons when not using it. The fastening system to my Toyota Highlander factory rack is secure but a little cumbersome to apply and take off. I like to take it off when not using it to preserve my gas mileage. The boards and skis fit fine although they are stacked in order to get 4 peoples worth of equipment up there. A small price to pay for their compact size on the roof or in the garage.

Decent rack for the money. The locks are a bit finicky due to the metal/composite combination. They definitely require graphite lubricant regularly. I've only used it with 2 pair of skis and it works well.

Howzit etrailer.com & staff. the rack itself is sturdy and more aero than comparable units. For my 2017 Subaru Crosstrek (OEM) Aero Bars, it was necessary to shim the (rear) lower/leading edge clamp assembly with two 1/8” x 1.5” x 1.5” (EPDM) rubber pads. The bars are shaped like a wing – and these shims helped to level the rear rack with the one in front. Overall - it looks very clean and functional. I might screw on some rubber ends over the ends of the mounting bolt to complete the project. Time to make some turns. Thank you!!