Socket Size that is Between 3/4 inch and 11/16 inch

Question

Question:

2001 F350 existing Ford acorn bumper nuts: Seems like 3/4 is too big and 11/16 is too small. Is it an 18mm or 23/32? Either way, I will have to go to the store.

asked by: Fred

0

Expert Reply:

A 3/4 inch socket is right at 19 mm and a 11/16 socket is right at 17.5 mm. An 18 mm socket would be right in the middle between the two and should work well for you.

expert reply by: Jameson C

0

Answer 1

The difference is found in the application. The Slipper Spring styles, like part #SP-179275, are intended for use with more heavy duty applications, while the Double Eye styles, like part #e77SR are used to provide a more comfortable ride. The part…

view full answer...

Answer 2

Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…

view full answer...

Answer 3

The Curt Front Mount Trailer Hitch Receiver #C31014 is the only front receiver that we currently offer for your 2001 Ford F-350 that does not require you to remove the front bumper. For it to mount your F-350 must have the blocker beam on the front.…

view full answer...

Answer 4

I can help and there is a front mounted hitch that is a fit for your 2006 Ford F-250 and I recommend the Draw-Tite #65022, which will sit in the opening through the front bumper. It is a 2" hitch with 9,000 lbs of line pull and a vertical load…

view full answer...

Answer 5

Both the Draw Tite hitches part #65022 and #65005 have a wall thickness of 3/8 inch.

view full answer...

Answer 6

The Bulldog Winch Receiver Mount Kit #BDW20155 has the standard 10 x 4.5" mounting bolt pattern which will match up exactly with your Badland Apex 12000. As for the wiring, you will need to route the wire from your 4Runner battery and mount the…

view full answer...

Answer 7

We have two front mount receivers available for a 2004 F-450 cab and chassis. They are Draw-Tite part #65022 and Curt part #31114. I have added links to these parts and their install instructions below. I did some geometry with your 8 on 9 inch lug…

view full answer...

Answer 8

Thanks for reaching out Denis, I'd love to clear the air for you! While I don't have info on the factory that the Draw-Tite Front Mount Trailer Hitch Receiver #65022 is made at, what I can say is that Draw-Tite is one of the leading hitch…

view full answer...

Answer 9

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Socket Size that is Between 3/4 inch and 11/16 inch

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching