Determining The Correct Size Spade Terminal Connector For The Triple Rocker Switch # 37212025

Question

Question:

What size connectors would be used to connect wires to this switch?

asked by: Jim

0

Expert Reply:

To connect to the Triple Rocker Switch # 37212025 you'll need a 1/4" female spade terminal connector and will need to know the gauge of the wire you're connecting to the switch. For example, the Female Spade Terminal Quick-Disconnect # DW01899-1 would connect to the pins on the switch and crimps onto 14 - 16 gauge wire. For 10 - 12 gauge wire or if you're splicing multiple wires to one connector then you could go with a larger gauge option like the # RM-300115-00.

expert reply by: Kevin C

0

Answer 1

I have a solution for you that is very similar but the switches of the JR Triple Switch setup part #37212025 are not removable. Instead you'd want the Triple Bezel RV Switch Faceplate #37213625 and the part #37212585 for the SPST switches and the…

view full answer...

Answer 2

We do have some triple rocker switch panels you can use for your 2019 Forest River Forester, but they don't have the light up feature when they are powered up. The standard switch kit we have is from JR Products and comes in the following colors:…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

Answer 11

The Dexter Trailer Idler Hub Assembly for 3,500-lb Axles item #84545UC1-EZ fits a item #L68149 bearing which has a 1.378" inner diameter. I would not recommend using this hub on a boat trailer. Instead, you'll want a galvanized one like item…

view full answer...

Answer 12

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

Determining The Correct Size Spade Terminal Connector For The Triple Rocker Switch # 37212025

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching