Recommended Lights for CM Trucks 1510304 Flatbed

Question

Question:

Need light package for a CM flatbed model 1510304 Led

asked by: Wade

1

Helpful Expert Reply:

Based on my research the CM Trucks 1510304 uses the standard size oval lights on the flatbed. For stop, tail, turn lights you can use the # STL602RB. For reverse lights we have the # BUL602CB, or if you want a backup and tail function the # BUL602CRB. You will also want the PVC Grommet # a70gb and 3-Wire Pigtail for Optronics Trailer Lights # A45PB for installation.

expert reply by: Robin H

1

Answer 1

You should have 3 wires at the rear of your LED light, or from a pigtail like part #A47PB, that plugs into a light like part #STL22RB. The red wire will be connected to your stop/turn circuit on your vehicle. The black wire is spliced into your…

view full answer...

Answer 2

You gave me a lot of info on your trailer, but what I really need first is the dimensions of the spindle on your trailer so that we can determine what hub/drums you would need. You also will need to know if you have brake mounting flanges on your…

view full answer...

Answer 3

The only open eye 1-3/4" wide leaf springs we currently carry is the etrailer #e24SR & #e33SR. I have no way to verify the weight capacity for your current springs but as it is only a 2" square axle this spring is likely much heavier…

view full answer...

Answer 4

Which two lids in particular were you looking at? Without knowing, it's hard to comment but I'd be happy to run you through the process of how to choose the correct replacement vent lid for your RV. The first thing to consider when choosing a…

view full answer...

Answer 5

I looked up pictures of Texas Pride car haulers and based on what I saw the Optronics LED Trailer Tail Light part #STL72RB is the correct replacement. If you need the grommet too you'd want the part #a70gb.

view full answer...

Answer 6

According to my research your TDE 46845 trailer hub fits a #84 spindle so the replacement bearing and seal kit you need is part #BK2-100. This is for a single hub so you'll need to adjust the quantity as needed. Attached is a video showing this…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK will fit perfectly in the opening you measured on your trailer. Replacement trailer lights can be confusing at times because each manufacturer uses slightly different dimensions so the…

view full answer...

Answer 9

The difference in overall diameter between 4.80-8 and 4.80-12 size trailer tires is about 4-1/2 inches. A smaller tire will clearly not create a clearance issue around fenders where a larger size could. The two tires' widths are fairly close to…

view full answer...

Recommended Lights for CM Trucks 1510304 Flatbed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching