What Is The Thickness Of The 12 X 2 Hydraulic Trailer Brake Shoe Lining BP04-160?
Question:
what is the thickness of the linings? i have a rear lining that is 3/16inch and front lining that is roughly 1/16. is a hydraulic single servo unit
asked by: Shawn K
0
Expert Reply:
I went out to the warehouse and measured the thickness of the 12" x 2" Hydraulic Trailer Brake Shoe and Lining # BP04-160 that you mention, and measured:
-6.16 MM for the inner thickness,
&
-8.10 MM for the brake lining thickness.
I have included a picture of # BP04-160 with these measurements for you to check out.
expert reply by:
Bryce D
0
12x2 Hydraulic Trailer Brake Shoe Lining Dimensions
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
12" x 2" Hydraulic Trailer Brake Shoe and Lining (One Wheel)
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- RH
- Brake Shoes
- 12 x 2 Inch
- Redline
more information >
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Brake Controller Connector Location on a 2019 Ford E-350
- Q&A: Replacement Bushing Options for Lippert Never Fail Bushings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Hubs and Electric Brake Assemblies for M1010A2 Military Trailer
- Q&A: Replacement Hub and Brakes for M101A2 Trailer
- Q&A: Axletek-12-GG Replacement Brake Assembly and Hub Recommendation
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Q&A: Comparing Demco and Titan Disc Brake Actuators with Electric Lockouts
- Q&A: Parts Needed To Swap Out The Axle On A 1991 M101A2 Military Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)