Recommended Roof Rack For 2016 Honda Odyssey To Carry 103lb Hobie Kayak

Question

Question:

Just purchased a Hobie Outback. Fitted hull weight 85 pounds Fully rigged 103 pounds I have a 2016 Honda Odessey no roof racks So I need a rack I’m 72 and not so strong so thought I could do a assisted with a winch but I can get that done later. Thanks so much for your help.

asked by: Marjorie T

0

Expert Reply:

Congratulations on the new kayak!

For your 2016 Honda Odyssey I recommend the Thule Roof Rack System using 60" Thule WingBar Evo Crossbars # TH711520, and Evo Raised Rail Feet # TH710401 if your vehicles has the factory raised side rails running front to back. If it has a bare roof you will need the 53" Thule Crossbars # TH711420, Thule Top Track Mounting System # THTP42, Rapid Podium Feet # TH460R, and Fit Kit # THKIT3101.

Both of these kits have a 165lb weight capacity which is plenty for your 103lb Kayak, but you will need to verify the weight rating of your roof to make sure you will not be overloading it.

For a kayak carrier I recommend taking a look at the etrailer J-Style Carrier # e98878 which has a 150lb weight capacity, and will fit the above crossbars perfectly. If your garage allows you to store the Kayak on the ceiling then the Malone Kayak Hammock Hoist # MPG346 would be a great option as it allows you to easily load and unload the kayak from the roof of your vehicle.

I will say with the weight of your kayak and you being worried about putting it on the roof you would have a much easier time with a trailer like the Malone EcoLight Sport Trailer with J-Style Carriers for 2 Kayaks # MAL93FR would be a much easier option as you would not have to pick up the kayak much to get it loaded.

I included a few videos of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

Hey Tim, thanks for reaching out. Generally, with long bed trucks like your Ram 3500, turning clearance will not be an issue, so the offset ball would not be needed. If you want to be 100% sure, you can use the following formula to determine your…

view full answer...

Answer 2

The Malone MegaWing, part #MPG207 and the SeaWing, part #MPG107MD are extremely similar and come in Malone's distinctive red styling, but have different applications. Its not the wrong picture, just not a great one to notice the differences. I…

view full answer...

Answer 3

Yes, I think the Malone MegaWing Fishing Kayak Carrier, #MPG207, will work well with your kayaks. The reinforced Wing-style saddles with rubber padding should handle the hull design just fine and the way the straps come over the kayak to cinch it in,…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Timothy, this is a great question but what Curt means by vertically in terms of bike racks for the Curt hitch part #C47MJ is a different style of bike rack but I can see the confusion. For example a vertical bike rack is the Yakima HangTight part…

view full answer...

Answer 8

Hi Anthony; the forces applied to the #C22HR hitch and the frame from a vertical hanging bike rack (bike racks that require the bicycles to be hung / mounted vertically) are different from your standard platform rack like the #HLY94FR or hanging bike…

view full answer...

Answer 9

Hey Mike! To answer your first question yes, the Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter #RP59KR can replace the Curt Helux. This is compatible with the Rhino bolt pattern which is the same thing the Helux fits. I don't…

view full answer...

Recommended Roof Rack For 2016 Honda Odyssey To Carry 103lb Hobie Kayak

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching