Replacement Key CH503 For Tractor Supply Truck Tool Box

Question

Question:

Does this key work for my tractor supply tool box also

asked by: Dariel

0

Expert Reply:

If your Tractor Supply tool box lock cylinder is stamped with the CH503 than the Replacement Key # KEYCH503 is the correct replacement key. The keys and lock cylinders can be used across a large variety of products.

expert reply by: Bud M

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 6

Hey Robert, basically what you need to add brakes to a trailer is three things. The correct hub/drums to replace your idler hubs, brake assemblies, and wire to wire up the assemblies. To pick out the correct hub/drums we need two pieces of info. The…

view full answer...

Answer 7

In order to determine which replacement key you will need for your UWS Truck Toolbox, you will need to get the code off of the lock core. I have attached a picture for you showing the location. The code should start with CH and followed by 3 numbers.…

view full answer...

Answer 8

Thank you for the photos! To replace your old Lippert (LCI) slam latch you can use the Lippert Standard Baggage Door Latch Kit - Black #LC317649, which is going to be the same size as your old slam latch and will fit perfectly in the existing cutout…

view full answer...

Answer 9

The H-Channel #36281-955(93-1/2 Long x 2 Tall x 1-1/8 Deep) you found is the only size H-Channel we currently carry.

view full answer...

Answer 10

I checked with TRC and they sent me the following pictures for the Flat Rub Rail Trim for Enclosed Trailer #36286-955 that you referenced.

view full answer...

Answer 11

I do have an option for you but we only offer the H-Channel for Enclosed Trailers part #36281-955 is one size, 93-1/2" long x 2" tall x 1-1/8" deep. That said, we do offer a C-Channel for Enclosed Trailers in 93-1/2" long x…

view full answer...

Answer 12

For a hitch lock to fit a 3 inch trailer hitch like what you have you would want the part #FA86-00-3160. This lock is designed to fit the larger 3 inch hitch size you have so it would work well.

view full answer...

Replacement Key CH503 For Tractor Supply Truck Tool Box

Product Page this Question was Asked From

Continue Researching