Replacement Winch For 1998 Starcraft Ventura 2406 Pop Up Camper

Question

Question:

I wanted to know if this part would be a good replacement for my winch. I have a 1998 Starcraft Ventura pop up model # 2406. Thank you for your time. It is a single cable design and the winch is mounted to the front of the pop up trailer.

asked by: Colin C

0

Expert Reply:

The Dutton-Lainson Hand Winch # DL14934 works as a replacement for the old Shelby 5438 that has been found on other 1998 Starcraft pop ups. If your 1998 Starcraft Ventura 2406 has the same Shelby 5438 than you should not have any issues replacing it with the Winch # DL14934.

expert reply by: Bud M

0

Answer 1

The Dutton-Lainson Hand Winch w/ Automatic Brake #DL14934 will work as an excellent replacement for your Shelby 5438 lift system with the 4 cables. We've had a number of people who've used this in the exact same situation as you and it's…

view full answer...

Answer 2

Great question! I believe that you're wanting to extend that handle out horizontally so that you aren't having to 1 - get on your hands and knees while operating the winch, and 2 - having to keep removing and installing the handle because it…

view full answer...

Answer 3

The Shelby winch part #5351 that you mentioned is no longer available but it was a 1,000 lb winch with a 2 way ratchet. Dutton Lainson actually bought Shelby so the most similar winch would probably be the Dutton Lainson part #DL14934 which is a…

view full answer...

Answer 4

I do have a winch replacement option for you, but unfortunately there is no direct replacement for your older Shelby 5438 winch in your pop up camper. I recommend the Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - 1,200 lbs…

view full answer...

Answer 5

I have attached for you below a dimensional drawing of the Dutton-Lainson Hand Winch with Automatic Brake part #DL14934 which you can then use to determine fit and compatibility. I am not sure how your existing winch is setup but you can use the…

view full answer...

Answer 6

I do have a solution for you, but it will not include replacing a wheel on your existing winch. Your Shelby Winch, model 5351, is a 1,000 lbs winch with a 2-way ratchet. If you need to replace your existing winch I recommend a winch by Dutton…

view full answer...

Answer 7

We have a winch that will work to replace your Shelby 5353 but we do not carry the exact winch you have. I recommend part #DL14958 which is a Dutton-Lainson single speed winch rated for 2,500 lb and has an automatic brake.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Replacement Winch For 1998 Starcraft Ventura 2406 Pop Up Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching