Troubleshooting A Lighting Issue On A G6A-8E Water Heater
Question:
I have a g6a-8e water heater. When I turn on the propane and try to fire up the water heater, it ignites, but wont stay lit more than a few seconds. Ive tried unplugging the 4 wire connection on the board and plugging it back in. It clicks on but the igniter keeps clicking and the flame goes outI have replaced the gas valve and a new spark probe. Is the problem with the circuit board? Thank you.
asked by: Wayne M
Helpful Expert Reply:
Since you already replaced the spark probe it's most likely the control board on your G6A-8E water heater with the Replacement Control Panel for Atwood Water Heaters Item # AT91367. You may also want to replace the wire harness Item # AT93312 as there could be a short or some kind of damage in one of the wires causing a miscommunication.
Product Page this Question was Asked From
Replacement Control Panel for Atwood Water Heaters
- Accessories and Parts
- RV Water Heater
- Control Panel
- Atwood
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Control Panel for Atwood Water Heater with AVM93256 Control Panel
- Q&A: Replacement Control Panel for Atwood 91349 Water Heater
- Q&A: Replacement For Atwood 91349 Control Panel
- Q&A: Replacement Circuit Board for Atwood G6A-8E Water Heater 96220 or 96121
- Q&A: Replacement Control Panel For An Atwood GC10A-3E RV Water Heater
- Q&A: Replacement Hot Water Heater Control Board For Atwood Water Heater with Control Board 90098
- Q&A: Replacement Motor for Kwikee Motor Assembly 214-1009
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure a Trailer Axle