Torque Specifications for Installing etrailer Receiver Hitch e98846 on 2015 Nissan Rogue

Question

Question:

What is the required torque in tightening the bolts

asked by: Ronald L

0

Expert Reply:

The Torque Specification is found in the installation instructions on our product page on the etrailer # e98846 receiver hitch. A Torque Wrench # PT87ZR would be the type that you would need to achieve that rating.

expert reply by: Bud M

0

Answer 1

The Tow Ready 2 Inch Hitch Ball, part #63845, you have referenced needs to be torqued to 250 foot pounds. It is recommended to frequently check that the ball is tightened to these specifications. If you are meaning the mounting bolts that are used to…

view full answer...

Answer 2

The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75282 requires all hardware be torqued to 68 foot pounds according to the instructions. I've attached a photo in case you need anything else for this installation…

view full answer...

Answer 3

According to my contact at Tekonsha, the connector you're looking for will only be present if the bumper sensors are dealer-installed. If the parking sensors were factory installed, the connector will NOT be present, and the blue wire in question…

view full answer...

Answer 4

The Draw-Tite #DT85MR and etrailer.com #e93ZR Class III hitches will be evenly matched in weight capacities for your 2021 Nissan Rogue, so we can disregard the capacities for this comparison. Especially since your Rogue can tow, when properly…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

What you can do is use a bolt leader like #80101-1 with a carriage bolt block through an open portion of your frame to basically act as a weld nut so you can install the hitch. This normally is a solution we use when a vehicle has a broken weld nut…

view full answer...

Answer 7

According to the instructions that I have linked below the 5 bolts used are M12-1.25 x 35mm for the etrailer Trailer Hitch Receiver #e98846.

view full answer...

Answer 8

The trailer hitch I recommend for a 2018 Nissan Rogue is the etrailer Trailer Hitch Receiver part #e98846. It features a bolt-on fit with no drilling required. It also has a hidden design so only the receiver tube will be shown. In regards to the…

view full answer...

Answer 9

The maximum tongue load is 110lbs on your 2018 Nissan Rogue per the owners manual. This means the scooter carrier you would use will need to weight less than that to be safely transported on the vehicle. While trailer hitches like our own…

view full answer...

Answer 10

Hey Rich, thanks for reaching out! The hitch profiles for a 2022 Tucson and your 2024 Nissan Rogue are different so you unfortunately won't be able to just swap them over. To get a new hitch for your Rogue I recommend picking up the etrailer…

view full answer...

Answer 11

The Curt trailer wiring harness part #C56331 will not work properly without the power wire hooked up. This harness uses the taillight circuits of your vehicle as signal wires but then draws all the power for the trailer taillights from the vehicle…

view full answer...

Torque Specifications for Installing etrailer Receiver Hitch e98846 on 2015 Nissan Rogue

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching