How to Install the Uni-Lite LED Clearance and Marker Light  

The Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Amber Lens #MCL11AKB can be mounted in a piece of metal up to 1/4" thick. If you needed to mount it in anything thicker then I recommend caulking it in place…

The hole size needed for installation of the Sealed, Uni-Lite Mini LED Side Marker and Clearance Light, part #MCL11AKB, is 11/16 inches, see photo at right. The Grommet will fit in the space between the light and the drilled hole.

The grommet on the Uni-Lite Clearance and Side Marker Light #MCL11AKB is 7/16 inches in total height,and the inner channel is 1/4 inches. I would make sure that whatever metal you are installing this into is slightly less that 1/4 inches thick.

We definitely have the wiring and brackets needed to get you up and running. With that being said, you will need the Right Angle 2-Wire Pigtail #A46PB and the Mounting Bracket for Optronics AL91 #A91BOB. The #AL91AB lights will snap into the #A91BOB…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…