Using Go Power Automatic Transfer Switch to Switch Between Shore Power and Solar Power

Question:

planning on installing solar panels, what do i need to make for the go power to work plus shore power/generator if cloudy/rainy. i have a fifth wheel manufactured by grand design model #385gk solitude. the battery installed at the moment is lithium deep cycle 300 ah still thinking of ordering another one just so it can be factored in the calculations.

asked by: Sonny B

Helpful Expert Reply:

The Go Power Automatic Transfer Switch # 34264403 that you referenced is a good way to automatically switch between shore power (when available) and an inverter that's being powered by solar charged batteries. It is always going to use shore power if it's present, and as long as the inverter is on, it will automatically switch to it once shore power is disconnected.

For this type of setup, starting at the roof, you will of course first need the solar panels like the 220 watt # 34272628. This particular kit includes the needed controller/regulator, but if you already have some panels you will need to make sure this is added. The controller ensures that the batteries aren't overcharged

From the controller the wiring will go to the battery bank, and from there to an inverter like the Go Power 2,000 Watt # 34278156. This will take the DC output from the batteries and convert it to AC power for your appliances and the transfer switch.

I have attached a diagram my contact at Go Power sent me that shows a really similar setup that you might find helpful.

expert reply by: Chris R

click to enlarge

Rey I.

5/25/2020

Hello, My RV shore power is 50 amp, Can I use a this 30amp transfer switch for my solar panels?

Chris R.

5/28/2020

Since you have 50 amp shore power, I would use the 50 amp Transfer Switch # F50ATS instead. Using the 30 amp model would limit the amount of power you have for your accessories.

Rey I.

6/3/2020

@ChrisR Thank you very much for your response.