How Much Should It Cost To Completely Rewire a Trailer
Question:
I am handicapped and need to get my 20 foot trailer rewired to OEM, they said I needed a breakaway theyre going to put in a junction box and run brand new wire for my 7 plug wire connector. I thought they were charging a lot$1000but maybe its okay how much should it cost, or is that a just price I havent said anything to them because I dont know if they are charging too much or if thats what its worth or more
asked by: Misty N
Expert Reply:
I can give you a list of parts below that will be needed to rewire a trailer which you can then use when combined with the labor rate of the shop to give you an estimate but it can be very hard to estimate the price of said job because the labor rates for shops can vary quite drastically. If you think one shop is charging too much, I would shop around and compare prices but I can't really give you a yes or no answer in regards to whether or not they are charging too much.
Tekonsha Push-To-Test Trailer Breakaway Kit part # 50-85-313
Trailer Wiring 7-Way Upgrade Kit part # HS381-9000
Bonded 4 Wire part # 16-4B-1
Hopkins Trailer Wiring Installation Kit part # HM51010

Products Referenced in This Question
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Hopkins Trailer Wiring Installation Kit
- Wiring
- Tools for Wiring
- Wiring Kits
- Installation Kit
- Hopkins
more information >
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Product Page this Question was Asked From
Tekonsha Trailer Breakaway Kit w/ Charger, LED Tester, and 5 Ah Battery - Top Load
- Trailer Breakaway Kit
- Kit with Charger
- Top Load
- Single-axle
- Tandem-axle
- Triple-axle
- LED Tester
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Most Popular Wheel Bearings
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Shop: 6-Leaf Slipper Spring w/ Hook End for 8,000-lb Trailer Axles - 29-1/2" Long
- Shop: Brake Controller
- Shop: etrailer Rust-Resistant 6-Leaf Double Eye Spring for 7K Trailer Axles - 24-7/8" Long - Dacromet
- Shop: Easy Grease Trailer Hub and Drum Assembly for 5.2K - 7K Axles - 12" - 8 on 6.5 - Pre-Greased
- Shop: 14 Gauge, 4 Conductor Jacketed Wire - Per Foot
- Shop: Grease Seal - Double Lip - 2.250" ID - 3.376" OD - GS-2250DL
- Shop: Grease Seal - Double Lip - 2.125" ID - 3.376" OD - GS-2125DL
- Video: An In-Depth Look at the LubriMatic Multi-Purpose Lithium Grease
- Video: A Closer Look at the Prime Guard Red Hi-Temp Wheel Bearing Grease
- Video: Comprehensive Review: LubriMatic Multi-Purpose Lithium Grease
- Video: Timken Hi-Temp Red Grease for Disc and Drum Brakes: The Breakdown
- Q&A: Difference Between 7-Way Round and 7-Way Blade Connectors
- Q&A: Why Self Adjusting Brakes or Manual Adjust Trailer Brakes
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Dielectric Grease Review
- Search Results: 7 way plug
- Search Results: spring hangers
- Search Results: grote
- Search Results: grote tail light
- Search Results: tail lights
- Search Results: 12 gauge wiring
- Search Results: grease
- Video: Review of the Replacement Cable and Pin for Bright Way Trailer Breakaway Kits
- Video: Ultimate Overview of the Dielectric Grease for Electrical Connectors, 2 oz.
- Video: Deka Jacketed 4-Wire Review
- Q&A: Replacement Brake Assembly for Axletek 44-GG