Does Transmission Cooler Need to be Pre-Filled Before Install on Vehicle
Question:
Hi Im installing additional tr.oil cooler do I have to filll it with tr. fluid or it will be an over fill thanks
asked by: Denis K
Expert Reply:
When installing a transmission cooler it is not necessary to pre-fill the cooler with fluid. That will only cause a bigger mess most likely. It's not like an oil filter where it's a good idea to pre-fill before installing it.
You'll just want to install the cooler and then after that's completed check the fluid level on the dipstick and add additional fluid as needed. I'd grab an extra quart to have ready as typically some fluid gets lost during the install process and then you'll need to offset the additional volume that the cooler adds as well.
Product Page this Question was Asked From
Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class III - Efficient
- Transmission Coolers
- Plate-Fin Cooler
- Mid-Size Truck
- SUV
- Van
- Standard Mount
- 11W x 8-3/4T x 7/8D Inch
- With 11/32 Inch Hose Barb Inlets
- Derale
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Transmission Cooler Installation - 2011 Chevrolet Suburban
- Shop: Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class III - Efficient
- Shop: Derale Snap-In Radiator Adapter Fitting for GM
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers - Preorder
- Q&A: Transmission Cooler Recommendation for 2011 Chevy Silverado
- Q&A: Transmission Cooler Recommendation for a 2011 Chevy Silverado 1500 with 4.8 Liter Engine
- Article: Frequently Asked Questions About Transmission Coolers
- Shop: Trailer Hitch
- Shop: Firestone Coil-Rite Air Helper Springs - Rear Axle
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: 331~tpsi~002
- Search Results: trailer brake controller
- Q&A: Is it Okay to Use Trailer Spare that is Slightly Larger than Rest of Trailer Tires
- Q&A: Can Different Width Trailer Wheels Be Used On The Same Trailer?
- Q&A: Should a Transmission Cooler be Installed on a 2016 Honda Odyssey for Towing Just One Time
- Q&A: What is the Mounting Hole Size on E-Track
- Q&A: Wiring Diagram for Installing the Replacement Single Zone Thermostat for Dometic RV Air Conditioners
- Video: Install: Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets on a 2013 Honda Odyssey
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer hitch
- Video: Finding the Right Trailer Wiring Harness
- Search Results: brake controller
- Article: Trailer Wiring Diagrams
- Video: Ultimate Overview of the Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets
- Search Results: weight distribution hitch
- Article: How to Measure for Trailer Hitch Drop
- Video: Installing the etrailer Trailer Hitch Receiver on your 2000 Chevrolet Silverado
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
on Transmission Coolers
