Wire Colors for 7-Way Trailer Connector on a 2007 Ford F-250/F-350

Question

Question:

Color code for truck plug

asked by: James B

0

Expert Reply:

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires:

Orange = 12 Volt Power
White = Ground
Black/Green = Reverse
Blue = Brake Output
Yellow = Left Turn/Brake
Green = Right Turn/Brake
Brown = Running Lights

For a new 7-way trailer connector, I recommend using the Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket part # PK12-707E because all you need to do is strip the jacket off the ends of the above wires and then insert them into the back terminals on this connector.

expert reply by: Conner L

0

James

8/29/2024

So how is it? The little block picture doesn’t match the list of wire connections

Reply

Jon G.

8/29/2024

@James Follow the list that Conner gave. The photo was a standard wiring connection diagram that typically uses different colors but I removed it for you.

Reply

Answer 1

I reached out to Dexter and even with your axle tag they do not have any information on your axle since the it was ordered as a beam. In order to find if the Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal #BK3-100 is the correct replacement, you will…

view full answer...

Answer 2

We do offer the Optronics trailer light #MC32RB for red and #MC32AB for amber. These lights will be extremely similar to the #MCL31RB that you mentioned, but they are a bit more square on the ends. The mounting holes on the #MC32RB are 3" apart…

view full answer...

Answer 3

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 4

Yes, 14 gauge wire seems too small. I would go with 10 or 12 gauge. For 10 gauge you can use #10-1-1 and for 12 gauge use #12-1-1. These wires are sold in increments of 1 foot. So if you needed 20 feet of wire you would enter 20 in the quantity box.…

view full answer...

Answer 5

You will have to make sure that the alternate ground wire on the Hopkins in-bed trailer connector, #41157, is attached to a clean bare metal surface on the truck frame. If it is not then the harness will not work correctly. You can also try different…

view full answer...

Answer 6

To replace the wheel stud on your 122096 Lippert 7K hub and drum assembly you need the Kodiak part #K12WB2 which has the same 1/2" 20x2" specs.

view full answer...

Answer 7

The Replacement Amber Lens for Peterson Oval Clearance and Side Marker Lights #108-15A looks to be a close match and it measures 3-3/4" long x 1-5/8" tall x 15/16" deep so it should work just fine.

view full answer...

Answer 8

Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load #20400 can have the pin mounted on the coupler. The angle should be as aligned as possible with the point you are connecting to and be slightly shorter…

view full answer...

Answer 9

In order to convert the hydraulic disc brakes on your trailer to electric, you will need a electric over hydraulic (EOH) actuator and a breakaway kit. The HydraStar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes part #HS381-8067 is an…

view full answer...

Answer 10

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 11

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Wire Colors for 7-Way Trailer Connector on a 2007 Ford F-250/F-350

Product Page this Question was Asked From

Continue Researching