Replacement Pads For 4 Inch Wide Nerf Bars With 24 Inch Step Pad

Question

Question:

I have a 5 pin 4 inch wide 24 inch longoriginal equip nerf barb step pad thats broken do you have a replacement.

asked by: Anthony C

0

Expert Reply:

It sounds like you need the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 # 21-0001. You can see the measurements in the photo and that there are 6 pegs, but only 5 of them use the clips to hold the pads in place. You will also need 5 barrel clips, # 23-0002. The clips are sold as singles so you will need to change the quantity to 5.

expert reply by: Jason S

0

click to enlarge

Answer 1

The closest thing we have is the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 #21-0001. This pad has the 6 pins instead of the 4 pins you stated, but may fit based on the location of your 4 pins.

view full answer...

Answer 2

With 5 holes, you most likely have Westin nerf bars. I recommend the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 #21-0001 which are 24 inches by 4 inches.

view full answer...

Answer 3

Thank you for those dimensions, and I think we may have what you need for your Tacoma with the following part: - Replacement Step Pad for Westin Platinum Series Oval Nerf Bars #21-0001 I have added a photo with the measurements of this replacement…

view full answer...

Answer 4

We have a large selection of replacement step pads available for running boards like what are on your 2013 Toyota Tacoma. I cannot be positive as to what brand and model running boards you have, but we do have a replacement step pad available with…

view full answer...

Answer 5

Hey Donald! I'm assuming you're saying you have the deck rail system on your 2024 Tundra. Is that correct? Assuming it is, and you have the 5-1/2' bed, the Access Vanish Soft, Roll-Up Tonneau Cover #A28GW you looked at is the right one to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Dave, thanks for reaching out. The BAKFlip MX4 Hard Tonneau Cover #BAK99AV is the correct fit for your 2024 Toyota Tundra CrewMax SR5 with the 5.5' Bed. It clamps directly to the bed rails like the second installation method you mentioned.…

view full answer...

Answer 8

Hi Charles, Appreciate the specifics you provided, and that wheel is a white spoke Dexstar wheel, which we do have with a ST205/75R14 tire. You can use either of the following, depending on the load range you need: - Load Range C (1,925 lbs): Karrier…

view full answer...

Answer 9

It might David but I have no way of knowing for sure without that serial number. The Replacement Key Fob item #RTX36TR matches up with covers that have a serial number of 1701 or higher. There's no other way to identify if this is the one you…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Hi JD; if I had to choose between the Leer Hard Tonneau Cover #LE67FR and BAKFlip MX4 #BAK448133 I would go with the MX4. As far as security goes both are locking covers so it will be about the same between the two. The MX4 has seals and drain tubes…

view full answer...

Answer 12

Hey Tony, The etrailer Hard Tonneau Cover #e55DR does not come with a built in lock, but if you lock the tailgate of your truck then no would would be able to open the cover without damaging it or the tailgate.

view full answer...

Replacement Pads For 4 Inch Wide Nerf Bars With 24 Inch Step Pad

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching