Replacement Vent Cover For Jensen RV Roof Vent

Question

Question:

The trailer is a 1999 model, Pace is the manufacturer. This is a Jensen vent, im not sure what series. I bought the wrong cover so Im looking to get the correct one. I will send a picture of the hinge style, The cover thats in the pic is not the correct one its just up there to keep the rain out. hopefully you might know the correct style vent cover I need. Thanks.

asked by: Chad L

0

Expert Reply:

Most likely we have what you are looking for but you will need to first determine what vent style you have on your trailer.

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14".

To pick the correct cover, you will also need to know the type of hinge you need.

There is a 3 point hinge, such as the one on the Camco # CAM40153; a 4 point hinge as seen on the Camco # CAM40154; or a rolled metal continuous hinge like on the Ventline # BVD0449-A03; and universal hinge as shown on the MaxxAir # MA00-335001.

Basically the easiest way to select the correct replacement cover is to remove the existing cover and match the hinge and lift bracket to the photos on our site along with the dimensions. A link to all of the replacement vent covers is provided to match up with your cover.

If it is not clear which hinge style that you have, the MaxxAir above is a Universal Replacement Lid.

In the event that you don't find a lid you like, I also included a link to our main page for our complete 14 x 14-inch vent assemblies. These are offered in manual or powered lift and with or without fans. If you install a complete new vent you'll need an installation kit, either # 344270KITW for a metal or coated metal roof or kit # CAM25013 for a rubberized roof..

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

We have actually spoken with Ventline regarding your model AS-13 M-VD0449 in the past and they have confirmed that the correct replacement cover is the part #BVD0449-A03 in Smoke or #BVD0449-A01 in White. The cover measures 14 inches x 14 inches and…

view full answer...

Answer 2

It can be difficult to give a truly accurate estimate for the length of time it takes to install the Custom Third Brake Light Camera for 8" Factory Monitor #3460001 on your 2020 Ford F-350 Super Duty. The time really depends on how comfortable…

view full answer...

Answer 3

The Custom Third Brake Light Camera for 8" Factory Monitor part #3460001 could pretty easily be wired to an existing switch you have in the cab but I would not be able to offer much advice on this as it's designed to be used with the…

view full answer...

Answer 4

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 5

We have the Timbren Axle Less suspension kits that are really great trailer suspension solutions that don't use leaf springs. I attached a review video for this type of setup for you to check out that talks about how it work and install plus…

view full answer...

Answer 6

Yes, it is possible for yellowing of plastic to occur in high heat. Florida tends to do a great job of that in the summer. Since it doesn't look like anything is cracked I would say go ahead and throw some Krylon Fusion on there. When they start…

view full answer...

Answer 7

The Solera 14' Slider (Slide-Topper) in White w/ White Hardware #LCV000163301 comes with everything you need for installation except the #CAM25013 which is an 8 foot length that is shown in the video as you stated. I do recommend getting two of…

view full answer...

Answer 8

I've seen the instructions for the Truck Bed Cargo Camera #3460001 and they are adequate but not super detailed. We do have our review video, which I've linked for you, that quickly shows you where they ran the wiring. I took a picture of the…

view full answer...

Replacement Vent Cover For Jensen RV Roof Vent

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching