Replacement CH545 Keys for Trailer Mounted Toolbox

Question

Question:

I need replacement keys for CH545 lock on a gooseneck trailer toolbox.

asked by: Nate B

0

Expert Reply:

We carry the replacement key you're looking for as part # CHK545.

expert reply by: Mike L

0

Answer 1

Yes, we do have the correct replacement key for your battery door cover, it's the Replacement Key (545) for Steel Flush Door Latches part #CHK545.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 6

Hi Brian, While a lock isn't a necessity to use the 24x60 Reese Cargo Carrier for 2" Hitches #63153, the part you mentioned, the Anti-Rattle #63232 actually is a lock. It serves as both an anti-rattle device and a lock to secure the cargo…

view full answer...

Answer 7

Hello Mark. The only way to get replacement keys for a Curt 23518 hitch lock is if you happen to know they key number. The problem with this is the key number is printed on the key itself, so unless you happen to have the key number written down…

view full answer...

Answer 8

As you mentioned, the existing lock barrel is held in place by the retaining nut on the inside of the box. Try giving the nut a good shot of a spray penetrant and letting it soak for awhile. Apply a wrench to the nut, and use a crescent wrench to…

view full answer...

Answer 9

It is possible that there are separate left- and right-side tow package fuses on your vehicle. You will need to check your power distribution box to see if there are either missing or blown fuses. Please note that the part you referenced, Tow Ready…

view full answer...

Answer 10

To convert a trailer with hydraulic disc brakes to electric-over-hydraulic (EOH) actuator operation you will need to either replace or immobilize the existing surge coupler so it no longer compresses. A bolt installed horizontally through the coupler…

view full answer...

Answer 11

For your 2 inch diameter shank we only have the coarse thread option for the 2-5/16 inch hitch ball. If you can make that work, we have the 2-5/16" Hitch Ball - 2" Diameter x 3-1/2" Long Shank - Raw - 30,000 lbs #BWHB94009 and the…

view full answer...

Replacement CH545 Keys for Trailer Mounted Toolbox

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching